Tension Meter Strain Gauge Indicator For Tension Control System STM-050PD

Tension Meter Strain Gauge Indicator For Tension Control System STM-050PD

Tension Display Digital Tension Meter For Tension Control System In Cutting Machine

Features:

Key intelligently set zero, scaling, operation simple convenient.

1. Can select left /right total tension display.

2. Adapt SMT ,small size,light weight.

3. Tension controller with STS ans STSA for option.

4. Hardware and software to restrain power frequency interference, output steady and reliable.

5. Bedded installation,easy and convenient .

Attention:STM-050 tension meter only display tension,no control signal output,other functions same as STM-10PD.

Using steps

1. Enter C11 ,according to the tension sensor type to set C11 parameter value:if it is differential sensor,the value is set to 0,if it is strain gauge sensor,the value is set to 0.
2. When use the tension meter output to participate the control with PLC ,according to the actural need to set C09/C10.
3. Set the alarm value when it is needed,otherwise it has no alarm with 0.0kg.
4. According to the actual need to set C04 full degree of tension,its value should be 20%~80% of tension sensor rated range.

Notes for use

1. Set screw should not be too long when the bearing hourses are installed on the detector.
2. Use spherical universal bearing hourses.
3. The wrap angle of film over detector reel should not be larger than 120 around 60 would be perfect.
4. The load force caused by film tension should not point to he screw ends of tension detector.
5. The screw ends of tension detector should point upwards when installed on a wall.
6. If the force caused by film tension pulls but not pushes the tension detector,so the negative and positive detector signal wires should exchange when connected to the tension meter.

Romove faults

1. The mass of detected reel is too large,the rated value of the tension detector is too small,both will cause the fault alarm of signal is too large.

2. C11 parameter value is not match with the actual tension sensor type,it will cause the fault alarm of signal too large or signal too small.

3. The wrap angle of film overt detector reel is too large,the force caused by film tension point to the screw ends of tension detector,ot will cause the fault alarm of signal is too small.

4. The tension sensor connect is not correct,fropped or damaged,left amd right pressure is imbalance,it will cause the fault alarm.

5. The load id too large will caused the fault alarm of "more than limit‘

FAQ

1. When can I get the quotation?
We usually quoted within 12 hours after receiving your inquiry. If you are very urgent to get the price, please call us or tell us in your email, so that we can regard your inquiry priority.

2. How should I place the order?
Please let us know the model number based on our specs for tension controller,web guiding system. For powder clutch, powder brake, please show us your drawing, or let us know your request torque, and then we will provide you suitable model for confirmation.

3. What’s your MOQ basis?
Normally, we don’t have MOQ request.

4. What about the lead time for production?
Honestly, it depends on the order quantity and the type of our products. For tension controller, load cell and edge position controller which is about 1-3 days. For powder clutch, powder brake which need about 3-5days.

5. What is the term of delivery?
We can arrange with EXW, FOB, CIF…etc. You can choose the most convenient one or cost-effective way.